Shipping times may vary.
Contact help@islandbeachgear for details.
- TEN total rod holders. Six rod holders (three on each side) welded directly to the top railing and bottom wagon deck for added strength and durability. Rod holders welded on an angle to eliminate risk of breaking rods when hauling under overhead archways and gates. Four additional rod holders (two in the front and two in the rear) are also included and bolted to the 1.5″ x .75″ perimeter railing. Can be used for additional rods, umbrellas, cutting board accessories, surf or paddle board holders, etc.
- Rod holders are 9.25″ tall and made from 2″ round aluminum tube.
- Overall outside maximum width is less than 25″ allowing the wagon to glide easily through all standard entryways, doors and gates.
- Solid aluminum deck with corner drain holes. Deck size is 20″ x 36″ with a 2″ perimeter lip. Maximum interior bed dimensions are 18.5″ x 34.5″.
- The bottom of the wagon deck stands 12″ from the ground.
- Four-10” x 3.5” pneumatic four-ply tube tires allow the wagon to roll easily over rough terrain. ¾” bearings and grease fittings included.
- Solid ¾” round aluminum axles.
- Rust-free aluminum fabrication with stainless steel hardware. No maintenance required!
- Weighs only 55 lbs. and hauls up to 600 lbs!!!
- Minimal assembly required.
- MADE IN THE USA!!!
*This item is oversized and is excluded from free shipping offers.
* This item is not available for Store Pickup at this time.
The same amazing top of the line features always offered by Alumacart. All aluminum fabrication with stainless steel hardware create a lightweight, rust-free powerhouse of a fishing wagon. Make a day at the beach fun again! No more struggling to haul all your gear to the shore! Bring the Sidekick for a stress and strenuous free day of fishing.
|Made in the USA||Yes|